Salzgitter improves LD converter (BOF) process with automation upgrade from Primetals Technologies

Primetals Technologies has recently implemented an upgrade of the LD converter (BOF) process optimization system at Salzgitter Flachstahl in Salzgitter, Germany. The new Slag Expert model has optimized the use of lime, improved the hitting rate – i.e. the amount of successful heats in terms of carbon content and steel temperature – and reduced the number of reblows.

Slag Expert is a new module for Primetals Technologies’ process optimization system (Level 2) that calculates the target value for the required basicity of the slag at the end of the blowing process. Additionally, it provides the basis for determining the optimum amount of lime.

Exceeding expectations

The process optimization system from Primetals Technologies has already been in use at Salzgitter Flachstahl’s three 220-ton LD converters (BOFs) for 15 years. Christian Schlüter, Head of Melting Operations, on the results achieved with the new Slag Expert module: “We were able to meet the identified improvements after just a few weeks, and we even exceeded them in some cases. The most important aspect for us is to optimize the input of lime in order to meet the required phosphorus levels.” Startup, fine-tuning, and the initial monitoring of the production process were largely accomplished remotely by the team from Primetals Technologies.

Slag Expert calculates the desired slag basicity at the end of the blowing process based on the amount of silicon in the feedstock, a pig iron analysis, and the targeted parameters of temperature, carbon, and phosphorus content in the crude steel composition. The availability of stirring plugs and the age of the converter are also taken into account. Furthermore, the Slag Expert module calculates the values for lime saturation, phosphorus capacity, and viscosity of the slag.

Eliminates interruptions

The main objective with Slag Expert is to provide operators with exact data on the amount of feedstock and oxygen required to produce the desired steel quality on time. This is ensured by combining Slag Expert with the Dynacon process model and an off-gas measurement system for LD converters (BOFs) to determine the optimal timing of the end of the blowing process. With the support of these systems, interruptions to the blowing process caused by the taking of measurements and samples are largely eliminated.

Long-term collaboration

The Slag Expert module is a result of many years of close collaboration between Salzgitter Flachstahl and Primetals Technologies. For more than 10 years, the process optimization systems have been maintained and improved as part of a services contract. In addition to the Level 2 systems at the LD converters (BOFs), this cooperation also focuses on automating the complete secondary metallurgical process as well as topics related to intralogistics and, for example, scrap management.

Share this story

Picture of Green Steel World Editorial Team

Green Steel World Editorial Team

News brought to you by our editorial team. We are a knowledge platform – driving technology to the global green steel community. If you wish to contribute your press, please contact us.